Mitsubishi Electric FR-F740 EC Instruction Manual page 487

Parameter
The half-tone screened areas indicate the parameter initial values.
When Pr. 128 = "40, 41, 50, 51, 60, 61, 140, 141" and the operation mode is not NET, input
method is same as when Pr. 128 = "10, 11, 20, 21" respectively. Input from BACnet
communication is available when the operation mode is NET, Pr. 549 = "2" (BACnet), and
RS485 terminal has the command source. Input from LonWorks or CC-Link communication
is available when BACnet communication is inactive and the operation mode is NET.
For the setting method via LONWORKS communication, refer to the LONWORKS commu-
nication option (FR-A7NL) instruction manual.
For the setting method via CC-Link communication, refer to the CC-Link communication
option (FR-A7NC) instruction manual. For the setting method via BACnet communication,
refer to section 6.18.8.
When "100" or larger value is set to any of Pr. 190 to Pr. 196 "Output terminal function
selection", the terminal output has negative logic. (Refer to section 6.9.5 for details.)
If Pr. 133 is used for the set point signal (setting ≠ 9999) any additional set point signal
applied to terminals 2-5 will be ignored.
NOTE
Changing the terminal function using any of Pr. 178 to Pr. 189, 190 to Pr. 196 may affect the
other functions. Please make setting after confirming the function of each terminal.
FR-F700 EC
PID control
6 - 337