Mitsubishi Electric FR-F740 EC Instruction Manual page 113

Operation
Screen at powering on
The monitor display appears.
Press the MODE key to choose the parameter
setting mode.
Turn the digital dial until P.79 (Pr. 79) appears.
Press the SET key to show the currently set value.
The initial value "0" appears.
Turn the digital dial clockwise to change it
to the setting value of "4".
Press the SET key to set.
Press the MODE key twice to choose monitor/
frequency monitor.
Press the start switch FWD or REV to give the
start command.
Turn on the low speed switch (RL). The output
frequency increases to 10Hz according to Pr. 7
"Acceleration time".
Turn off the low speed switch (RL). The output
frequency decreases to 0Hz according to Pr. 8
"Deceleration time".
Turn off the start switch STOP/RESET.
Fig. 4-16: Operate the inverter by using multi-speed setting
FR-F700 EC
Operation
PU operation mode
Display
Flicker ... Parameter setting complete!
Low speed
Low speed
The parameter number
read previously
appears.
Flickering
I001073E
4 - 21