Robot Controller Connection - Mitsubishi Electric GOT1000 Series Handbook

4.2.3 Robot controller connection

System configuration
Target device
Ethernet
CRnD-700
10BASE-T cable
100BASE-TX cable
*1: Use a cable that supports a robot controller and Ethernet board/card to be used.
*2: For available Ethernet boards/cards, refer to the following page.
*3: The number of total GT SoftGOT1000 running in personal computer is included.
*4: Connect the PC CPU module to another programmable controller.
Available Ethernet board/card for GT SoftGOT1000
Manufacturer
3Com Corporation
-
170
4.2 Other MITSUBISHI controllers
4.2.3 Robot controller connection
cable
Communication unit
Not required
Built in GOT
Ethernet
Not required
*1 *5
Built in personal
computer
Commercially-available
Ethernet board
Programmable
controller CPU
EthernetLink LAN PC Card
Ethernet board included in personal computer as standard
GT15-J71E71-100
DOS/V
personal
computer
GOT
PC CPU
module
GT SoftGOT1000
License key for
GT SoftGOT1000
*5: When connecting GT16 to an equipment that meets the 10BASE (-T/2/5) standard,
use the switching hub and operate in an environment where 10Mbps and 100Mbps
can be mixed.
Model
GOT
Max. number of
GOTs connected
1
GT16
(16 units or less
are recommended.)
Max. connection
distance
Max. segment length
100 m
GT15
Max. number
of personal
computers
connected
1
GT SoftGOT1000
Max. connection
+
distance
License key for Max. segment length
100 m
GT SoftGOT1000
Max. number
of personal
computers
connected
1
+
Max. connection
distance
Max. segment length
100 m
Remark
Ethernet board/card
Ethernet board