Sharp Programmable Controller - Mitsubishi Electric GOT1000 Series Handbook

4.3.5 SHARP programmable controller

For details of the system configuration, refer to "Connection type" in section 4.3.1.
Connectable GOT
Connectable models
Series
JW-21CU
JW-31CUH
JW-50CUH
JW-22CU
JW-32CUH
JW-33CUH
JW-70CUH
JW-100CUH
JW-100CU
Z-512J
*1 Either RS-422 or RS-232 interface can be selected.
The GOT model to be used differs depending on the connection type.
Series
RS-232 or RS-422 connections
GT11 Bus connection
Handy GOT RS-232 or RS-422 connections
Available unit for computer link connection
Unit
Link unit
Precautions
Precautions on system
For connecting to a GOT, use a link unit applicable to the JW-31CUH, JW-32CUH, and JW-33CUH.
When connecting a GOT to the SHARP programmable controller, set a terminating resistor for the
programmable controller.
The GOT has a built-in terminating resistor.
Related Manuals
• For details of system configuration and
connection cable
• For precautions and restrictions
• For outlined procedure and checking for SHARP
programmable controller connection
• For controllers that can be monitored by GOT and
accessible range
• For connection method with Handy GOT
* For restrictions and precautions on controllers connected to a GOT, refer to the manual for each controller.
194
4.3 Third Party Programmable Controller
4.3.5 SHARP programmable controller
Computer link connection
RS-422
Connection type
GT115
GT115
GT115
JW-21CM
JW-10CM
ZW-10CM
RS-232
GOT model to be used
-Q BD
-Q BDQ, GT115 -Q BDA
HS-Q BD
RS-422
Chapter 14 in GOT1000 Series Connection Manual
(SH-080532ENG)
Chapter 2 in GT Designer2 Version2 Screen Design
Manual (For GOT1000 Series) (SH-080530ENG)
Chapter 14 in Handy GOT User's Manual
(JY997D20101)
Direct CPU connection
RS-422 RS-232
*1
*1
RS-232
-