Mitsubishi Electric GOT1000 Series Handbook page 265

Precautions
Precautions on setup
Connecting to personal computer
When connecting a personal computer, ground the ground cable of the personal computer.
Other precautions
Power supply of camcorder
Depending on the camcorder type, a programmable controller and GOT may malfunction due to noise
because of the power supply cable for a camcorder. In this case, attach the following line filter to the
power supply line.
Recommended line filter: ZHC2203-11 manufactured by TDK Corporation (or equivalent products)
Power supply of vision sensor
When using a camcorder via the vision sensor, a power supply unit of the vision sensor is required
according to the vision sensor type to be used.
Selecting output of video signal
The video signal can be output from both a power supply unit of a camcorder and a camcorder according
to the camcorder and system to be used.
When video signals are output from both the camcorder and power supply unit, the voltage levels for
some of the signals are reduced and images may not normally be displayed. In this case, output signals
only from the camcorder.
Powering on camcorder
Power on the camcorder simultaneously with a GOT.
Related Manuals
• For details of system configuration and
connection cable
• For precautions and restrictions
• For outlined procedure and checking of video/
RGB connection
* For restrictions and precautions on controllers connected to a GOT, refer to the manual for each controller.
Chapter 44 in GOT1000 Series Connection Manual
(SH-080532ENG)
4.7 Other Devices
4.7.4 Video/RGB connection
1
2
3
4
5
6
7
247