Work After Printing; Removing The Fabric Roll - Epson ML-13000 User Manual

ML-13000 User's Manual
O
Press the feed button (forward) on the rear panel to feed the fabric until the seam moves past the print head.
c
Important:
If the seam comes into contact with the print head during printing, the print head could be damaged. Be sure
to check that the seam has passed by the print heads before starting printing.
P
Check the message on the control panel and then restart printing.

Work After Printing

The workflow after printing is complete is as given below.

Removing the fabric roll

"Removing the Fabric Roll" on page 119
U
Inspection after printing is complete
Perform periodic inspections after turning on the power, and clean or replace parts if necessary.
"Inspection and Cleaning After Printing" on page 133
U
Turning Off the Power
See the following for details on how to turn off the power.
"Turning Off the Power" on page 133
U
Removing the Fabric Roll
See the following to remove the fabric roll installed on a 2 inch/3 inch feeding spindle.
"2 inch/3 inch Feeding Spindle" on page 96
U
See the following to remove the fabric roll installed on a 1-inch feeding spindle.
"1 inch Feeding Spindle" on page 101
U
Basic Operations
119