Removing The Motors - Epson 2200 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus PHOTO 2100/2200

4.2.13 Removing the Motors

4.2.13.1 Removing the CR Motor
1. Remove the Middle Housing. (Refer to 4.2.1.3.)
2. Remove the ASF Unit. (Refer to 4.2.4.)
3. Release the two hooks that secure the Paper Guide Manual, and pull and remove
the Paper Guide Manual to the front as viewed from the printer rear.
Cutouts
Hooks
Cutouts
Figure 4-105. Removing the Paper Guide Manual
When reinstalling the Paper Guide Manual, securely insert the 13
cutouts into the Under Frame and fix the two hooks.
When reinstalling the Paper Guide Manual, slide and push it from
the printer rear to the front.
Refer to Figure 4-105, "Removing the Paper Guide Manual".
Reinstall the Paper Guide Manual securely since the incorrectly
(unevenly) mounted Paper Guide Manual will incur a paper feed
fault in the manual feed mode.
Refer to Figure 4-105, "Removing the Paper Guide Manual".
DISASSEMBLY AND ASSEMBLY
4. Release the two (a total of four) hooks, which secure each of the Harness Clamps
to the Under Frame, with tweezers or a flat-blade screwdriver, and remove the two
Harness Clamps from the Under Frame.
5. Release the Connector Cable of the CR Motor from the Tie Wrap.
Cutouts
6. Disconnect the Connector Cable (CN17) of the CR Motor from the Main Board.
Cutouts
(Refer to Steps 2 and 3 in 4.2.2.2.)
7. Remove the Timing Belt from the Pinion Gear of the CR Motor.
(Refer to Steps 8 and 9 in 4.2.9.)
Disassembly
Harness Clamps
Hooks
Tie Wrap
Figure 4-106. Releasing the CR Motor Cable
Revision B
Hooks
168