Removing The Motors; Cr Motor - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.5 Removing the Motors

4.5.1 CR Motor

1. Remove the ASF Assy. (p.96)
2. Release the Carriage Lock, and move the Carriage Unit to the center.
Locking/Releasing the Carriage (p.65).)
3. Remove the two Clamps. (Refer to 4.4.13 Ink System Unit (p.107).)
4. Disconnect the CR Motor connector cable from the connector CN115 on the Main
Board.
5. Remove the CR Motor connector cable from the Cord Keep.
Cord Keep
CR Motor connector cable
Figure 4-146. Removing the CR Motor connector cable
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
(Refer to 4.1.5
Main Board
CN115
Removing the Motors
Attach two pieces of acetate tape (18 mm) on the Upper Shield
Plate.
Acetate tape (18mm)
Figure 4-147. Attaching acetate tape
Route the cables as shown below.
CR Motor connector cable
Pump Motor cable
Relay connector cable
Figure 4-148. Routing the cables
打印机驱动下载 http://www.printerwhy.com/
Revision A
Acetate tape (18mm)
Route the relay connector
cable over the Pump
Motor cable.
30mm ± 5mm
120
Confidential