Display Of The Results - KERN AES Operation Manual

There are two different ways to set the tolerance limits:
1. By weighing, that is by placing item on weighing balance and saving this
value.
2. Numeric entry of values via keyboard
• If a limiting value was set it remains saved until the balance is turned off.
• For the functions weighing, counting, percent individual limits can be set.
• When entering limits, pay particular attention to the type of classification
set (absolute/differential values).

11.7.2 Display of the results

The triangular tolerance marker ( ) in the display of the display shows whether the
goods to be weighed are within the two tolerance limits.
The tolerance marker is only in operation during operating mode tolerance weigh-
ing; it is otherwise not visible.
The tolerance marker provides the following information:
Bar graph display:
AES/AEJ-BA-e-0912
Goods to be weighed above tolerance limit
Goods to be weighed within tolerance range
Goods to be weighed below tolerance limit
Lower limit < Weight
Lower limit ≤ Weight ≤ Upper limit
Weight < Lower limit
55