Add-Up Without Auto-Tare - KERN AES Operation Manual

11.6.1 Add-up without AUTO-TARE

26. AD.N. 1
Menu setting [
Adding
1. Press the TARE-key and wait for zero to be dis-
played.
2. Deposit weight A
3. Wait until stability display [ ] appears and then
press the S-key. The displayed value is added
into the total adding memory.
The total [ ∑ ] is briefly shown
4. Remove load
or
leave load on weighing pan and reset display to
zero by pressing the TARE-key.
5. Wait until the balance zero display is shown, then
place weight B on balance
6. Wait until stability display [ ] appears and then
press the S-key. The displayed value is added
into the total adding memory.
The total [ ∑ ] is briefly shown.
Remove weight and place further weights on balance; for each weight, repeat step
2 to 4
Display "total"
Press the F-key repeatedly; total for all single
weighings will be displayed or switch-over to addi-
tional enabled functions will take place (see chpt.
11).
Delete total added memory
Display total and then press the TARE-key.
Back to weighing mode / start new add-up
process.
Press F key
52
]
a
0.0000
20.0000
30.0000
AES/AEJ-BA-e-0912
g
g
g