Printer Mode; How To Issue An Adjustment Protocol - KERN AES Operation Manual

Remarks:
• The performance delivered by the output control via the commands "O0~O7" or
setting the weighing balance functions is the same.
• Models "O8 and O9" are specifically designed for input commands.
• Once a command of "O0~O9" has been executed its status will remain enabled
until the next command is given. However, after turning off the weighing balance
output control returns to initial setting.

15 Printer mode

The following conditions must be met to provide successful communication between
the weighing balance and the printer.
• Use a suitable cable to connect the weighing balance to the interface of the
printer. Faultless operation requires an adequate KERN interface cable.
• Communication parameters (Baudrate, bits and parity) of weighing balance
and printer have to match, see chpt. 10.1.5 "Settings for serial interface".

15.1 How to issue an adjustment protocol

For menu settings [
An adjustment protocol is issued after completing an adjustment/adjustment test.
For sample protocols see chpt. 15.3.
82
] and [ Fq QoT 1 ], see chpt. 10.1
AES/AEJ-BA-e-0912