KERN AES Operation Manual page 62

5. Press and hold the TARE-key until the display
used for entering the limit appears.
Each time the TARE-key is pressed, numbers will
run through from 0-9 and the decimal point.
⇒ ⇒
0
Select the number to be changed using F key (the
active position flashes):
6. Save by pressing the S-key. The lower limit will
briefly be faded in, followed by [H. SET] (This
completes the entry provided only one limit is set
for tolerance control – menu setting [23.
7. Wait until the display starts flashing and the most
recently upper limit is displayed. Enter upper limit
by repeating 5-6.
8. Save by pressing the S-key.
The upper limit will briefly be faded in and the weigh-
ing balance returns to tolerance weighing mode.
Remove sample. From here evaluation takes place
whether the goods to be weighed are within the two
tolerance limits.
• Numeric entry of 3 or 4 limits
Menu setting [23.
P
For numeric entry of limits proceed as for entry of 2 limits. Instead of [L. SET] and
[H. SET] appears [L1. SET] - [L3. SET] or [L4. SET]. For this purpose repeat step 5
to 7 in each case.
62
1 ⇒ ≈ ⇒ ⇒
2 9
0
. 3] or [23.
P . 4].
1 1
P .1])
1
H. SET
1
0.0000
M
0.0000
AES/AEJ-BA-e-0912
g
g