Weighing With Freely Programmable Weighing Unit - KERN AES Operation Manual

11.4 Weighing with freely programmable weighing unit

The weighing value in [g] will automatically be multiplied by the variable factor set
and the result will be displayed (showing unit #).
Example:
A sheet of paper of the size 10 x 10 cm weighs 0.6 g – the task is to determine the
weight/1m². For this purpose the factor needs to be set to 100.
From this follows a display value of 0.6 g x 100 = 60.0 #, that is 60 g/m².
Activate function
In weighing mode keep the F-key pressed down
until [FWnm] appears on the display. Release but-
ton. The first menu item showing the current set-
ting will be displayed.
Press the TARE-key repeatedly until the menu
item "Weighing with freely programmable weigh-
ing unit" appears.
Confirm by pressing the S-key.
Enter the factor for the weighing unit
Press the F-key for about 4 seconds until
[C. SEt.] appears and then let go.
The most recently saved factor will be displayed
(flashing).
To enter the factor, press the TARE-key; the en-
abled digit starts flashing.
Each time the TARE-key is pressed, numbers will
run through from 0-9 and the decimal point.
⇒ ⇒ 1 ⇒
0
Select the number to be changed using F key (the
active position flashes):
Save the factor by pressing the S-key
or cancel the entry by pressing
the PRINT-key.
44
≈ ⇒ ⇒
2 9
0
Fonm
0
C.SET.
z000000
M
z000000
M
000000r5
AES/AEJ-BA-e-0912
#
#
#
#