5
Performing the MCU Initial Configuration
When you finish installing the MCU, you need to perform the initial configuration during which you
configure the basic features. After the initial configuration the MCU should be ready for use.
Setting the IP Address
Use the serial port on the MCU front panel to assign a new IP address to your MCU. You must assign
the IP address before you connect the MCU to the network.
Before You Begin
Make sure you have these items:
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
•
•
•
•
•
•
•
•
•
•
•
•
Dedicated IP address for the MCU
•
Dedicated subnet mask for the MCU
•
IP address of the default router the MCU uses to communicate over the network
•
PC with available serial port and terminal emulator software installed
•
Serial cable
Performing the MCU Initial Configuration | 29