Unpacking The Device - RADVision Scopia Elite 5100 Series Installation Manual

Unpacking the Device

We strongly recommend that you follow safety guidelines described in this section during
unpacking.
Procedure
Step 1
Inspect the shipping box to verify that it is not seriously damaged during shipping.
Step 2
Place the shipping box on a horizontal surface paying attention to the This Side Up symbol on the
shipping box. See
Caution
The accessories kit is situated on top of the device inside the shipping box and can be damaged if
the box is placed upside down. Pay attention to the This Side Up symbol on the shipping box to
handle the box correctly at all times.
Warning
To prevent injury and equipment damage, follow lifting guidelines described in the Safety
Guide when lifting or moving the shipping box.
Step 3
Cut the plastic straps.
Caution
The plastic straps are tightly stretched and can hit you when you cut them. To avoid this, make sure
you do not face the side of the box secured by the straps before you cut the straps.
Step 4
Cut the strapping tape.
Step 5
Open the shipping box.
Step 6
Take the accessories kit out of the shipping box.
Step 7
Take the device out of the shipping box.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 3-1 on page 14.
Figure 3-1 This Side Up symbol
Preparing the MCU Setup | 14