RADVision Scopia Elite 5100 Series Installation Manual page 22

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
•
Find a space on the rack which is at least 7 empty square holes in height on the rack posts.
The MCU takes up 3 holes (1U) on the posts. You need at least 2 additional holes to slide the
device into the rack.
See Figure 4-3 on page
Figure 4-3
•
To mount the MCU between two posts, the width between the inner sides of the two posts
must be at least 17.7 inches (45 cm). See
Figure 4-4
18.
Height of the MCU in the rack
Figure 4-4 on page
Width between inner sides of posts
18.
Setting up the MCU | 18