Locating a Shelf in the Rack
Before choosing a shelf that will support the device, follow this procedure.
Procedure
Step 1
Read
information.
Step 2
Prepare masking tape or a felt-tip pen to mark the location of the device-fixing cage nuts. If the
holes on the rack are marked with numbers, write down the numbers on a piece of paper.
Step 3
If you choose to mount the shelf, see the manufacturer's guidelines for mounting a shelf.
When looking for a location on the rack (see
•
•
•
•
•
Step 4
Ensure the shelf is positioned horizontally in the rack.
Step 5
Ensure the rack breaks are locked or the rack is stabilized.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
"Verifying Rack Suitability" on page
Choose a shelf on a rack with at least 1.73 inches (4.4 cm) of empty space above.
Verify that the shelf you want to use is properly mounted and secured.
Verify that the shelf can support the device weight. See
Verify a hole is present 0.20 inches (0.5 cm) above the shelf (measured from the center of
the hole).
Verify a second hole is present 1.46 inches (3.7 cm) above the shelf.
Figure 4-5
Checking the location of the shelf in the rack
17, which contains important positioning and spacing
Figure 4-5 on page
20):
Technical Specifications page
5.
Setting up the MCU | 20