RADVision Scopia Elite 5100 Series Installation Manual page 31

b.
c.
d.
e.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
On the rear side of the device, plug in the power cable into the AC power connector (see
Figure 4-13 on page 27).
Figure 4-13
Plug in the other end of the power cable into the mains.
Power on the device using the On/Off switch on the rear side of the device (see
on page 27).
Turn on the power distribution unit (PDU).
Rear panel of the device
Figure 4-14 Device front panel
Figure 4-13
Setting up the MCU | 27