Checking The Accessories Required For Mounting - RADVision Scopia Elite 5100 Series Installation Manual

Checking the Accessories Required for Mounting

Check you have the accessories necessary for mounting the device (see
Note:
Make sure you have a ruler, an Allen wrench (4 mm diameter), and a screwdriver (Nr. 1 tip) ready
to hand before you start the setup.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
•
2 mounting brackets (left and right)
•
4 cage nuts (M6) each with its hexagon socket cap screw (M6x10, DIN 7984)
•
8 Phillips screws.
Figure 4-6 Accessories required for mounting
Figure 4-6 on page 21):
Setting up the MCU | 21