RADVision Scopia Elite 5100 Series Installation Manual page 50

Step 2
Enter the webserverport command in the Command field.
Note:
Step 3
Enter the port value in the Value field.
Step 4
Select Execute.
Note:
Step 5
Select Yes to continue.
Step 6
Select Close.
Note:
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
To see the current port value, select Execute.
After selecting Execute, a warning message appears, notifying you that the unit will be
reset and any active conferences will be disconnected.
After applying the new port value, you must enter it as a suffix to the MCU IP address in
order to access the web server.
For example, if your new HTTP port value is 8080, access the web server by entering the
following:
http://<URL>:8080
Figure 5-15 CLI Section
Performing the MCU Initial Configuration | 46