Configuring The Tcp Port Range For H.245 On The Scopia Elite Mcu - RADVision Scopia Elite 5100 Series Installation Manual

Step 2
Set the video base port by doing the following:
a.
b.
c.
d.
e.
Step 3
Set the audio base port by doing the following:
a.
b.
c.
Step 4
Select Close.

Configuring the TCP Port Range for H.245 on the SCOPIA Elite MCU

The SCOPIA Elite MCU 5000 Series has designated TCP ports 1024-1324 for H.245. You can set the
base port, which is the lower end of the port range. H.245 is a Control Protocol used for
multimedia communication that enables transferring information about the device capabilities,
as well as opening/closing the logical channels that carry media streams.
The SCOPIA Elite 5100 Series MCU uses 150 ports for H.245, while the SCOPIA Elite 5200 Series
MCU uses 300 ports (except for the SCOPIA Elite MCU 5215, which has the same capacity as the
SCOPIA Elite 5100 Series MCU).
Procedure
Step 1
Navigate to the MCU Advanced Commands section by doing the following:
a.
b.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Enter the advcmdmpcsetval command in the Command field.
Enter the mf.BasePort parameter in the Parameter field.
Enter the port value in the Value field.
Select Execute.
Clear the value in the Parameter field before proceeding to the next step.
Enter the setmprtpbaseport command in the Command field.
Modify the port value in the Value field.
Select Execute.
Select the icon.
Select Advanced parameters.
Figure 5-13 CLI Section
Performing the MCU Initial Configuration | 44