Attaching Brackets to the MCU
The brackets serve to secure the device to the rack's front posts.
Procedure
Step 1
Position the device on a flat, horizontal surface. Make sure the device front panel faces toward
you.
Step 2
Unscrew the four black Phillips screws on either side of the device. See
Step 3
Attach the brackets on each side of the device side panel with the Phillips screws. See
on page
of the bracket.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 4-7
Removing the Phillips screws on the side panel
22. Use the Phillips screws of the accessories kit, as they have the same color as the metal
Figure 4-8
Aligning the bracket with the MCU front panel
Figure 4-7 on page
22.
Figure 4-8
Setting up the MCU | 22