RADVision Scopia Elite 5100 Series Installation Manual page 35

Step 12
Enter the subnet mask without leading zeros at the Subnet mask prompt and then press Enter.
Step 13
Enter the IP address of the router associated with the segment in which the unit will be installed
at the Default Router prompt and press Enter.
Step 14
Press Enter at the Preferred DNS prompt.
Step 15
Press Enter at the Alternate DNS prompt.
Step 16
Press Enter at the DNS suffix prompt.
Step 17
Enter Y.
Step 18
Enter Q at the prompt and press Enter.
Step 19
Allow the unit to complete the reboot process. A new emulator session begins.
Step 20
Close the terminal emulator session.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 5-2 Setting the IP Address
Performing the MCU Initial Configuration | 31