c.
Step 2
Enter the h245baseport command in the Command field.
Note:
Step 3
Modify the port value in the Value field.
Step 4
Select Execute.
Step 5
Select Close.
Configuring the HTTP Port on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated port 80 for HTTP. You can configure a different
port to use HTTP if necessary in your environment.
Procedure
Step 1
Navigate to the MCU Advanced Commands section by doing the following:
a.
b.
c.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Locate the CLI section and select More (see
To see the current port value, select Execute.
Select the
icon.
Select Advanced parameters.
Locate the CLI section and select More (see
Figure 5-13 on page
Figure 5-14
CLI Section
Figure 5-13 on page
44).
44).
Performing the MCU Initial Configuration | 45