Configuring the TCP/UDP/TLS Port for SIP on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated ports 5060 and 5061 for SIP. You can configure
a different port to use SIP (for example, if port 5060 or 5061 is busy).
Procedure
Step 1
Navigate to the MCU SIP Protocol section by selecting Configuration > Protocols.
Step 2
Locate the Enable SIP protocol section and select More (see
Step 3
Do one of the following:
•
•
Note:
If your SIP server or Registrar is configured with TLS, you can also configure the port value for
TCP/UDP traffic by modifying the Local signaling port field.
Step 4
Select Apply.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 5-19
If your SIP server or Registrar is not configured with TLS, enter the port value in the Local
signaling port field.
If your SIP server or Registrar is configured with TLS, enter the port value in the Local TLS
signaling port field.
Figure 5-19 on page
SIP Port Configuration
Performing the MCU Initial Configuration | 50
50).