Performing Basic Configuration - RADVision Scopia XT4000 Series User Manual

Note
Step 6

Performing Basic Configuration

Before you perform basic configuration for the Scopia XT Series, your system administrator
should install and activate your XT Series (for details, see the Quick Setup Guide for Scopia XT
Series, the Installation Guide for Scopia XT Series, and Safety Instructions leaflet for Scopia
XT Series.
To start using your Scopia XT Series, first define basic settings, such as the system's language,
the name of this endpoint, and network settings. This is relevant for both new installations,
and also after restoring default settings and re-installing software.
Note
Your system administrator might already have set these parameters for you and customized
certain features described in this guide to suit the environment of your company. If your
administrator set up PIN protection, you need the PIN number before continuing with the
configuration.
You can define these settings as follows:
For details on performing basic configuration, see:
RADVISION | User Guide for Scopia XT4000 Series Version 3.1.1
The code of the XT Remote Control Unit is changed and the Remote Control
new Remote Control code appear at the top-right corner of the screen:
The code and icon do not appear when the default code, 01, is used.
Set the code and exit by doing one of the following:
•
In the web interface, select Finish.
•
In the endpoint, press OK.
•
Following the quick setup procedure on the Scopia XT Series endpoint.
We recommend this method to quickly start using your Scopia XT Series, since the quick
setup wizard includes only the basic required settings.
•
Remotely defining the settings from the Scopia XT Series web interface (see
Scopia XT Series Web Interface" on page
Your administrator may define some settings remotely, such as for the network or
gatekeeper (see the Scopia XT Series Installation Guide for details). The quick setup is
available from the web interface if you have not already completed the procedure from
the endpoint.
You cannot remotely set the image on the monitor; this must be done from the endpoint
itself.
10).
icon with the
"Accessing
Getting Started | 17