RADVision Scopia Elite 5100 Series Installation Manual page 8

Note:
Note:
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
•
In-conference control
During a conference, participants can use their endpoint remote control or keypad to perform
actions such as mute, volume control, changing video layouts and inviting participants. These
options are presented in the in-meeting menu displayed on top of the video layout.
•
Optional no self see
The no self-see (NSS) option is enabled by default, but can be disabled with an advanced
command. This feature enables more effective use of the video screen.
•
Interactive Voice Response (IVR) messages
The MCU includes pre-recorded greetings to conference participants and announcements as
each new participant joins the conference. You can record messages to provide custom
greetings and announcements.
If your MCU deployment includes iVIEW Management Suite, use the IVR from your iVIEW
Management Suite.
•
Video switching
The MCU supports the switching of HD resolutions 720p and 1080p at the capacity of up to 120
calls, depending on the video resolution and call bitrate. Video switching is available for
H.264 and H.261 video codecs.
When using switched video, all endpoints in the conference must support the same resolution.
If a network experiences high packet loss, switched video might not be displayed properly for
all endpoints in the conference.
•
Dual NIC support
The MCU enhances security within the enterprise by routing media and management traffic
to two different subnets. For more information, see the Configuring a Dual NIC MCU section
in the Installation Guide of SCOPIA Elite MCU.
•
Recording via moderator menu
Moderators can record meetings using the MCU moderator menu.
This feature is only relevant if your SCOPIA Desktop deployment includes the recording
option.
About the SCOPIA Elite MCU | 4