RADVision Scopia Elite 5100 Series Installation Manual page 45

Dual-NIC functionality requires two subnets, where each subnet must have its own router or
default gateway.
Procedure
Step 1
Connect the network cable of the management subnet to the left ethernet port only, and activate
the unit.
Note:
Step 2
Access the MCU in a web browser and login.
Step 3
Select the Configuration
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 5-11 Two Ethernet connectors of the SCOPIA Elite MCU
Do not connect the media subnet cable until the MCU has been reset at the end of this
procedure.
tab.
Performing the MCU Initial Configuration | 41