Configuring Ports On All Models Of The Scopia Elite Mcu; Limiting The Udp Port Ranges For Rtp/Rtcp On The Scopia Elite Mcu - RADVision Scopia Elite 5100 Series Installation Manual

Mcu
Hide thumbs Also See for Scopia Elite 5100 Series:
Table of Contents

Advertisement

Configuring Ports on All Models of the SCOPIA Elite MCU

This section provides instructions of how to configure the following ports and port ranges on the
SCOPIA Elite MCU 5000 Series, including the SCOPIA Elite 5100 Series MCU and the SCOPIA Elite
5200 Series MCU:

Limiting the UDP Port Ranges for RTP/RTCP on the SCOPIA Elite MCU

The SCOPIA Elite MCU 5000 Series has designated UDP ports 12000-13200 (for video) and
16384-16984 (for audio) for RTP/RTCP. To provide additional security for your firewall, you can
limit these ranges.
Every call uses two audio ports and six video ports. For highly utilized systems (above 90%), we
recommend multiplying the number of total ports (for all calls) by a factor of 1.5.
Using its full capacity, the SCOPIA Elite 5100 Series MCU uses 180 ports for audio and 540 ports
for video, and the SCOPIA Elite 5200 Series MCU uses 360 ports for audio and 1080 ports for video
(except for the SCOPIA Elite MCU 5215, which has the same capacity as the SCOPIA Elite 5100
Series MCU).
Procedure
Step 1
Navigate to the MCU Advanced Commands section by doing the following:
a.
b.
c.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring the HTTP Port on the SCOPIA Elite MCU ..................................... page 45
Configuring the TCP Port Q.931 on the SCOPIA Elite MCU............................... page 48
Select the
icon.
Select Advanced parameters.
Locate the CLI section and select More (see
Figure 5-13 on page
44).
Performing the MCU Initial Configuration | 43

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scopia elite 5105Scopia elite 5110Scopia elite 5115

Table of Contents