Status Indicator; Rfrc-Opt Radion Receiver; Remote Programming Software; Programming Key / Firmware Upgrade Key - Bosch AMAX panel 4000 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
5.6.5

Status Indicator

Table describes the receiver's status based on the LED condition.
On
Off
Turns on momentarily
Flashes rapidly for less than one
minute
Flashes rapidly for more than
one minute
5.7

RFRC-OPT Radion Receiver

General Information
The RFRC Opt Radion Receiver allows the use of wireless devices using AMAX panel 4000.
Installation
Address Setting
AMAX 4000 panel supports one receiver only.
Wiring
Connect RFRC - OPT Radion Receiver to Bosch opton Bus 1 or 2.
Status Indicator
5.8

Remote Programming Software

It can be remotely connected to the software ITS-A-LINK PLUS developed by Bosch or the
third-party software integrated with BOSCH SDK to program the alarm control panel. The
software can access all the options and functions and manage and maintain event records and
service reports.
For more information about ITS-A-LINK PLUS, see User Guide.
5.9

Programming Key / Firmware Upgrade Key

The programming key can copy and store all programming information in the alarm control
panel. Firmware Upgrade Key is used for firmware upgrade.
Bosch Sicherheitsysteme GmbH
LED Condition
Installation Guide
Optional Modules and Peripheral Devices | en
The receiver is functioning normally.
A power failure occurred or the receiver is not correctly
wired.
The receiver acknowledged receiving a message from a
compatible transmitter
The receiver is being programmed with zone and
transmitter IDs from the compatible panel. This condition
occurs at system initialization (power up) or when new
zone information is programmed into the system. The rapid
flashing lasts less than one minute.
The receiver failed power-up self tests. Replace the
receiver
Indicates
2013.07 | 03 | F.01U.267.112
27