Bosch AMAX panel 4000 Installation Manual page 24

24 en | Optional Modules and Peripheral Devices
Figure 5.15: Wall Tamper Jumper
–
–
Figure 5.16: Rear of Receiver
Notice!
Cause of Hazard
Gently press the spring onto the tapered shaft. Do not force it down onto the shaft
Mounting the Receiver
• Determine the receiver's mounting location.
• If not already done, remove the receiver's cover (as shown in Figure 5.13).
• Place the receiver base on the wall at the desired mounting location and mark the two
mounting holes (see Figure 5.17).
2013.07 | 03 | F.01U.267.112
Wall Tamper
Jumper
Wall Tamper disabled
(Default position
Replace the inner cover.
Place the spring from the hardware packet over the shaft of the tamper switch located on
the back of the receiver (see Figure 5.16).
Rear of Receiver
R B G Y
ADDR
Wall Tamper enabled
)
Jumper left on pin for storage only.
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitsysteme GmbH
EN