AMAX panel 4000 / AMAX panel 4000
EN
For more information about indicators, see B426 Installation and Operating Guide.
5.4.7
Test
The alarm control panel tests the communication normally with the module. In case of
communication failure, a fault report with the module address is sent.
5.5
ITS-DX4020-G Communication Module
5.5.1
Brief Introduction
Conettix ITS-DX4020-G GPRS communication module allows IP communication via commercial
GPRS network. Transmission of alarm information via GPRS is the default for ITS-DX4020-G.
SMS or USB mode can be chosen for configuration. The remote programming and control of
the alarm control panel is supported.
The alarm control panel supports up to two communication modules.
–
–
5.5.2
Installation
1.
2.
3.
4.
5.5.3
Connection
When ITS-DX4020-G is used for communication with the alarm control panel, the bus address
should be set to 134.
The connection of ITS-DX4020-G and the alarm control panel is divided into two modes: GPRS
and GSM.
Bosch Sicherheitsysteme GmbH
1 ITS-DX4020-G and 1 B426, or
2 B426
Before installing ITS-DX4020-G, all power supplies of the control panel should be
disconnected.
Insert SIM card.
Use the standard three-hole installation mode to install ITS-DX4020-G in the enclosure of
the alarm control panel or another enclosure.
Connect the magnetic antenna ITS-DX4020-G.
Optional Modules and Peripheral Devices | en
Installation Guide
21
2013.07 | 03 | F.01U.267.112