Device Status And Reset - Bosch PRAESENSA Installation Manual

PRAESENSA
6.4

Device status and reset

Status
All PRAESENSA 19"‑devices have a small section on their rear panel for status monitoring,
comprising a:
–
–
Reset
A pinhole gives access to the hidden reset switch. This switch resets the device to its factory
default settings. It clears the OMNEO pre‑shared key (PSK) for secure connections and clears
the complete local configuration and reference data.
For the system controller it also clears the complete system configuration, all messages, user
authentication information, security certificates, time zone, NTP settings and all event logs!
Bosch Security Systems B.V.
Device fault present
Identification mode /
Indicator test
Green LED to show the device is powered. The green LED will blink when the device is in
identification mode during configuration.
Yellow LED to show that a device fault is present. This may be convenient during
installation and servicing.
Device reset (to factory
default)
Yellow
All LEDs blink
Button
Installation manual
From installation to configuration | en
Power on
51
Green
2019.11 | V1.00 |