Zone Tamper Bypass When Deol Zone Is Bypassed; System Settings - Rf Options; Area Settings; Common Area - Bosch AMAX panel 4000 Installation Manual

78 en | Settings
AC Fault Report Settings
In case of AC power fault, the fault report will be delayed for 1 hour or 10 minutes, or
transmitted along with other reports. The AC power fault event will be displayed on the
keypad 1 hour or 10 minutes later.
Fault Display Settings
In case of date/time settings fault, it is possible to choose to display the fault or transmit fault
prompt tone at the same time, or do not display and stop fault prompt tone. If it is chosen not
to display, even the fault prompt tone is set, the system will prompt nothing if no date and
time are set after power-up.
Version Information
This setting can be used to display the version number of the alarm control panel software.
Restoring to Default Settings
This setting can be used to restore all programming parameters set in the factory.
7.5.19

Zone Tamper Bypass when DEOL Zone is Bypassed

If Parameter Zone Tamper Bypass when DEOL Zone is Bypassed is enabled, system creates a
tamper alarm when DEOL zone is tampered, even when this zone is bypassed. Modify address
0184 in order to change parameter. This function is only accessible in address programming.
Also refer to Chapter Dual IP Settings, page 107 for more details.
7.6

System Settings - RF Options

RF Receiver Functionality
Enables or disables RF receiver functionality
RF Supervision Interval
Defines RF Supervision Interval
RF Jam Detect Level
Defines RF jam detect level
RF Device Low Level Battery Resound
Enables or disables RF device low level battery resound
Chirp On Arm / Disarm
Enables or disables chirp on arm / disarm
Keyfob Panic Option
Defines keyfob panic option
7.7

Area Settings

7.7.1

Common Area

Area 1 can be used as a common area or an independent area. Common area ancillary acts as
follows:
–
–
–
2013.07 | 03 | F.01U.267.112
Only all belonged independent areas are armed, the common area can be armed.
When a relevant ancillary area is perimeter arming, the common area will be perimeter
arming too.
When a relevant ancillary area is disarmed, the common area will be armed.
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitsysteme GmbH
EN