Reset To Factory Default Settings; Programming With Keypad; Lcd Keypad Menu Programming - Bosch AMAX panel 4000 Installation Manual

82 en | Configuration
8.4

Reset to Factory Default Settings

The factory Default can be reset with the 'Resetting to Factory Default' pads on the main
board of the control panel.
1.
2.
3.
4.
5.
6.
Notice!
If the DEFAULT pads are short-circuited for over 10 seconds after power-up, the control panel
will discard resetting to factory Default.
8.5

Programming with Keypad

8.5.1

LCD Keypad Menu Programming

1.
2.
3.
4.
5.
6.
2013.07 | 03 | F.01U.267.112
Disconnect the AC power supply and backup battery to the control panel.
Short-circuit the 'Resetting to Factory Default' pads.
These set of pads are located at the top on the printed circuit board of the control panel.
Powering up is done when the bonding pads are short-circuited.
Quick flash of the red LED indicator on the printed circuit board of the control panel
indicates that the factory Default will be reset.
All programming parameters are reset to factory default immediately after releasing the
short-circuited bonding pads.
Enable Text keypad and confirm that the system is in disarmed status.
Enter Installer Code + [958] and press [#] to get to [Installer Menu].
Programming: Select the menu and operate according to the menu prompt.
– Down to the next menu: Press [▼]
– Up to the previous menu: Press [▲]
– Enter menu or confirm input: Press [#]
– Back to the menu or delete a single input: Press [-]; or press and hold [-] for 3
seconds to end the input state and get back to the menu.
– Operate according to the menu prompt. Select menu and enter data for specific
programming items according to the display on the keypad to complete
programming, step by step.
– The data value ranges in the menu programming and address programming are the
same. For specific options and value ranges, see contents in LCD Keypad Menu
Programming.
After completing input, press [-] to get back to the previous menu. Complete all
programming input by repeating step 3 and press [-] to get back to the current main
menu level by level.
Press [-] to enter menu options. It is optional to save or not to save the programming
information.
Select [Save and Exit] and press [#] to save system programming data, exit menu
programming and reset system.
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitsysteme GmbH
EN