Settings; Communication And Reporting; Receiver Telephone Number /Ip Address And Port - Bosch AMAX panel 4000 Installation Manual

32 en | Settings
7

Settings

This chapter specifies the properties and the behavior of the AMAX panel 4000.
7.1

Communication and Reporting

This section outlines the programming information required for the AMAX panel 4000 / AMAX
panel 4000 EN when communicating with a base station receiver. These parameters specify
the telephone numbers/IP address to be called, transmission formats and internet
communication options.
7.1.1

Receiver Telephone number /IP Address and Port

The control panel can report event information from four on-board dialers. The dialers report
to Receiver 1 to Receiver 4 by programming. You can program each dialer with 4 separate
telephone numbers/IP addresses and ports, reporting format type and subscriber ID number,
and internet communication options if necessary.
Example
You can set up Dialer 1 to report to receiver 1 in CFSK Format and set up Dialer 2, Dialer 3
and Dialer 4 to report to a base station receiver in Contact ID Format only if Dialer 1 is
unsuccessful.
To program a telephone number:
Each address in the telephone numbers stores one digit of the telephone number.
Insert a 15 at the end of a telephone number to indicate to the dialer that the end of the
telephone number is reached. The dialing sequence is terminated when a 15 appears.
Example
To program the telephone number 9672 1055 as the Telephone Number for Receiver 1,
program the following sequence into Address 000 - 016:
[9 6 7 2 1 0 5 5 15 x x x x x x x x] x stands for any digit. To enter a 4-sec pause in the dialing
sequence, program a 13. A pause might be necessary when the dialer communicates through
an old (slower) telephone exchange or when a PABX system is in place.
Example
To program the number 02 pause 9672 1055, enter:
[0 2 13 9 6 7 2 1 0 5 5 15 x x x x x].
The following table shows how to program the numbers, keys, and functions for a telephone
number.
Digit Required
0
1
2
3
4
5
6
7
Table 7.1: Dialing Digits
2013.07 | 03 | F.01U.267.112
Number to Program
0
1
2
3
4
5
6
7
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Digit Required
8
9
*
#
4 sec pause
Terminal
Bosch Sicherheitsysteme GmbH
EN
Number to Program
8
9
11
12
13
15