18
en | Optional Modules and Peripheral Devices
DX3010
Figure 5.8: Connecting DX3010 to the Control Panel with External Power Supply
Notice!
When the external power supply is used, the black wire (-) is not allowed to be grounded.
5.3.3
Address Setting
Notice!
When data bus address is changed, the module needs to be re-powered to make the new
address effective.
Each DX3010 module connected to the alarm control panel must have its own data bus
address. For details refer to the Table below.
Module
DX3010 module 1 (Output 5 ~ 12)
DX3010 module 2 (Output 13 ~ 20)
Table 5.7: DX3010 Address Settings
For Address DIP switch settings, refer to the Table below.
DIP Switch
Data Bus Address
2013.07 | 03 | F.01U.267.112
Alarm Control Panel
Yellow
Green
Black (-)
Red (+)
(+)
(-)
External Power Supply
S1
1
Installation Guide
Data Bus Address
150
151
S2
S3
2
4
AMAX panel 4000 / AMAX panel 4000
S4
S5
8
16
Bosch Sicherheitsysteme GmbH
EN
S6
Mode