Bosch AMAX panel 4000 Installation Manual page 109

AMAX panel 4000 / AMAX panel 4000
EN
System Status Report (Zone fail, comm. fail, telephone
line fail, AC fail, low batterie...etc.)
Keypad Panic Alarm Report
Keypad Fire Alarm Report
Keypad Medical Alarm Report
Automatic Test Report
0 = No report, 1 = Receiver 1, 2 = Receiver 2, 3 = Receiver 3, 4 = Receiver 4, 5 = Receiver
1,2,3 and 4, 6 = Receiver 1 (2,3 and 4 for backup), 7 = Receiver 1 (2 for backup) and receiver
3 (4 for backup)
Notice!
When the Transmission Format for Receiver in the receiver programming is set to 0 (not
used), i.e., setting the report option as sending report to a receiver, then the alarm control
panel will actually not send any report.
Automatic Test Report
Address 0129 - 0134
Test Report Time: Interval
00 = Do not use timing report , 01 - 99 = 1 - 99 hours
Report Time: Hour
00 - 23 = 0 - 23 hours, Others = Do not use real-time
report
Report Time: Minute
00 - 59 = 0 - 59 minutes, Others = Do not use real-time
report
Report Expiry Time
Address 0135 - 0137
000 = No time limit, 001 - 255 = 1 - 255 minutes
Installer Access Until Next Arming
Address 0138
0 = disabled, 1 = enabled
Force Arm When System Is In Trouble Condition
Address 0139
0 = disabled, 1 = enabled
Bosch Sicherheitsysteme GmbH Installation Guide
Programming | en
0124 6
EN=1/5/6/7
0125 0
0126 0
0127 0
0128 6
EN=1/5/6/7
Address Default
0129 - 0130 24
VDS-A
EN=1-24
0131 - 0132 99
0133 - 0134 99
Address Default
0135 - 0137 000
VDS-A
EN=000
Address Default
0138 0
VDS-A=1
Address Default
139 1
VDS-A EN=0
2013.07 | 03 | F.01U.267.112
109