Led/Lcd Keypad Programming - Bosch AMAX panel 4000 Installation Manual

90 en | Configuration
8.5.2

LED/LCD Keypad Programming

1.
2.
3.
4.
For LED/Icon LCD keypad, the programming data is displayed by the keypad indicator. See
Programming Data Indicators.
Notice!
For LED/Icon LCD keypad, when the programming data exceeds the display range of the
keypad indicator, there will be no display on the keypad.
Programming Data Indicators
Data
Value
2013.07 | 03 | F.01U.267.112
Enable LED keypad or Icon LCD keypad and make sure that the system is in disarmed
status.
Enter programming mode: Enter the Installer Code (the default is 1234) + [958] and
press [#].
Programming: Move to the required address and enter the value for each data bit (data
value).
– After entering programming mode, the system directly enters the programming data
in the address 0000 (Receiver 1 telephone number or the initial digit of the IP
address), then
– Enter the next address: Press [#]
– Back to the previous address: Press [*]
– Skip to other address: Enter the address code and press [#]
– Set new data in the address: Enter new data values and press [*]
– Enter new data values as required. Otherwise, the factory Default will be used in the
system.
Exit programming mode: Enter Command [9] [6] [0] and press [#] to save programming
data. Entering [9] [5] [9] + [#] means not to save the programming data.
Zone Indicators
1 2
0
1 X
2 X
3
4
5
6
7
8
9 X
10
11 X
12 X
13
3 4 5
X
X
X
X
Installation Guide
AMAX panel 4000 / AMAX panel 4000
6 7 8
X
X
X
X
Bosch Sicherheitsysteme GmbH
EN
Mains
X
X
X
X