Rf 3227E Rf Receiver; Brief Introduction; Installation - Bosch AMAX panel 4000 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
5.6

RF 3227E RF Receiver

5.6.1

Brief Introduction

The RF3227E RF Receiver allows the use of wireless devices using AMAX panel 4000.
5.6.2

Installation

Considerations
The receiver should be mounted in a central location in regard to all wireless sensors,
whenever possible.
The receiver should be mounted vertically with at least 25 cm clearance above it for the
antennas.
Avoid mounting the receiver in areas with significant metal or electrical wiring such as furnace
rooms or utility rooms. If this is unavoidable, mount the receiver with the antennas extending
above any metal surface.
Avoid mounting the receiver in areas where it may be exposed to moisture.
Reception distances are generally improved with higher mounting locations and with no metal
objects near the antennas.
Setting Up the Wall Tamper
Notice!
If not using the wall tamper, proceed to Mounting the Receiver, page 24
To enable the wall tamper switch:
–
Figure 5.13: Removing the Cover
–
Press latch
the inner cover.
Figure 5.14: Removing the Inner Cover
–
Bosch Sicherheitsysteme GmbH
Remove the cover of the receiver (see Figure 5.13).
Insert screwdriver here and press in.
Remove the inner cover by pressing the latch.
Cover
Tamper
to remove
Move the wall tamper jumper as shown in Figure 5.15.
Optional Modules and Peripheral Devices | en
R G
B
ADDR
Installation Guide
Y
2013.07 | 03 | F.01U.267.112
23