Dx3010 Output Expansion Module; Installation; Wiring - Bosch AMAX panel 4000 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
5.3

DX3010 Output Expansion Module

5.3.1

Installation

The alarm control panel supports up to two DX3010 output expansion modules. The module is
connected to Bosch option bus1 or 2. Each module supports eight fully programmable relay
outputs. Like on-board output, DX3010 can be programmed as the output following the area
such as alarm event, arming / disarming status event and zone alarm event.
For more information about installation, see DX3010 Installation Guide.
Also refer to , page 28 for more details.
5.3.2

Wiring

When the module is placed in the enclosure of the alarm control panel, the power supply for
the control panel or external power supply can be used. For separate installation, the external
power supply must be used.
Power Supply
Alarm Control Panel
External Power Supply
Table 5.6: Lengths of cable for DX3010
For details refer to the Figure below.
DX3010
Figure 5.7: Connecting DX3010 to the Control Panel
When connecting to an external power supply refer to the following figure.
Bosch Sicherheitsysteme GmbH
Wire diameter of 0.8mm
12.2m
305m
Alarm Control Panel
Yellow
Green
Black (-)
Red (+)
Installation Guide
Optional Modules and Peripheral Devices | en
Wire diameter of 1.2mm
24.4m
610m
2013.07 | 03 | F.01U.267.112
17