Valve Mechanism Adjustment - MV Agusta Brutale Oro-S Workshop Manual

VALVE MECHANISM ADJUSTMENT

Check and adjust
B
Remove in order the following components to carry out
the measuring of the play between the camshaft and
the valve cups:
• Passenger seat
• Rider seat
• Left tank side panel
• Right tank side panel
• Ignition switch cover
• Fuel tank
• Air filter compartment
• Throttle body
N.B.: For all removal operations, including the relative
attention notes, please refer to the specific sections in
this manual.
An analogous reference is utilised for the reassembly
of the parts after the maintenance operation.
After having removed the indicated components, the
motorcycle is shown in the condition described by the
photograph on the left.
Before proceeding with the various maintenance ope-
rations, it is advisable to thoroughly wash and clean
the motorcycle.
Place the motorcycle (now without the components
listed above and clean) on a workstation as indicated
in the figure.
Apply adhesive paper tape to the frame tubes.
This operation will protect the paintwork from knocks,
scratches and abrasions that could occur during the
work activity.
Maintenance
at 1000 kilometres and
every 12000 kilometres
- 22 -