Engine Pic -Up; Timing Wheel Gap - MV Agusta Brutale 990 R Workshop Manual

Air intake injection system
ENGINE PICK-UP
The r.p.m./TDC sensor is of an inductive type and is
situated on the left side of the motorcycle.
To check this component it is necessary to identify the
relative connector positioned as shown in the figure,
inside the frame on the right side of the motorcycle.
D
After having disconnected the pick-up connector, mea-
sure the resistance between the two points identified by
(+) and a (-) that are indicated on the connector.
Pick-up resistance value: ~ 680 ÷ 700Ω

TIMING WHEEL GAP

To guarantee the correct functioning of the pick-up it is
necessary to measure the gap between the pick-up
and the timing wheel, that is to say the distance
between the pick-up and the timing wheel by utilising a
feeler gauge as shown in the figure.
GAP width: 0,6 ÷ 0,7 mm
To carry out this check it is necessary to remove the
cover of the timing wheel by consulting the Workshop
Engine Manual.
- 14 -