Gearchange Position Switch; Side Stand Switch - MV Agusta Brutale Oro-S Workshop Manual

GEARCHANGE POSITION SWITCH

The connector of the gearchange position switch is
placed in the proximity of the side stand and motorcy-
cle speed sensor connectors.
The connector of the gearchange position switch dif-
fers from the side stand connector since it is identified
by an S marked on the electric system sheathing.
Disconnect the connector of the gearchange position
switch and utilising a multi-tester, check the continuity
between the black lead and earth with the gears in
neutral.
ON (Neutral)
E OFF (Neutral exluded)
When the connector of the gearchange posi-
tion switch is connected and disconnected,
be sure to turn the ignition switch to the
"OFF" position to avoid damaging the elec-
tronic parts.

SIDE STAND SWITCH

The connector for the lateral stand switch is mounted
on a support under the pinion wheel transmission
casing on the left side of the motorcycle.
- Disconnect the connector of the side stand switch.
Utilising a multi-tester, check the continuity as indica-
ted in the table.
ON (Raised)
OFF (Lowered)
Electrical system
Black Engine earth
Green Brown Black
- 36 -