DSC indicator light
If the above lights are illuminated, dismount the vehicle from the chassis dynamometer
and turn the ignition switch to the LOCK position. Then, turn the ignition switch back to
the ON position, run the vehicle at 10 km/h or more and verify that the warning lights
go out. In this case, a DTC will be stored in the memory. Clear the DTC from the memory
by following the memory clearing procedure [ABS]/[DSC] in the on-board diagnostic
system. (See
ON-BOARD DIAGNOSIS
[ABS])(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL
(DSC)])
< Previous Next >
Back to Top
© 2010 Mazda North American Operations, U.S.A.