No.25 Engine Stalls When Driving At Slow Speed Or Stopping; No.26 Starter Does Not Work; No.27 Gear Position Indicator Light Does Not Illuminate In M Range - Mazda Mazda6 Workshop Manual Supplement

Diagnostic procedure
STEP
• Go to symptom troubleshooting No.4
1
"Engine stalls-after start/at idle".
(See Section F.)
• Is engine control system okay?
• Remove torque converter.
2
• Inspect torque converter.
(See ATX Workshop Manual.)
• Is torque converter okay?
• Verify test results.
3
— If okay, return to diagnostic index to service any additional symptoms.
— If malfunction remains, inspect related Service Informations and perform repair or diagnosis.
— If vehicle repaired, troubleshooting completed.
— If vehicle not repaired or additional diagnostic information not available, replace TCM.
End Of Sie

NO.25 ENGINE STALLS WHEN DRIVING AT SLOW SPEED OR STOPPING

25 Engine stalls when driving at slow speeds or stopping
• Engine stalls when brake pedal depressed while driving at low speed or stopping.
DESCRIPTION
• Malfunction is on engine control side (e.g. Fuel injection control, IAC system)
POSSIBLE
Note
CAUSE
• Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic
Diagnostic procedure
STEP
• Go to symptom troubleshooting No.10 "Low
1
idle/stalls during deceleration".
(See Section F.)
• Is engine control system okay?
• Verify test results.
2
— If okay, return to diagnostic index to service any additional symptoms.
— If malfunction remains, inspect related Service Informations and perform repair or diagnosis.
— If vehicle repaired, troubleshooting completed.
— If vehicle not repaired or additional diagnostic information not available, replace TCM.
End Of Sie

NO.26 STARTER DOES NOT WORK

26 Starter does not work
• Starter does not work even when P or N position.
DESCRIPTION
• Selector lever misadjustment.
POSSIBLE
• TR switch misadjustment.
CAUSE
• Open or short circuit in TR switch.
End Of Sie

NO.27 GEAR POSITION INDICATOR LIGHT DOES NOT ILLUMINATE IN M RANGE

27 Gear position indicator light does not illuminate in M range
• Gear position indicator light in instrument cluster does not illuminate in M range and ignition switch at
DESCRIPTION
on.
• M range switch, gear position indicator light or related wiring harness malfunction.
POSSIBLE
Note
CAUSE
• Before following troubleshooting steps, make sure that Automatic Transaxle On-Board Diagnostic
Diagnostic procedure
STEP
• Are other indicator lights illuminated with
1
ignition switch on?
K2–200
TROUBLESHOOTING
INSPECTION
and Automatic Transaxle Basic Inspection are conducted.
INSPECTION
and Automatic Transaxle Basic Inspection are conducted.
INSPECTION
Yes Go to next step.
No Repair or replace any defective parts according to
inspection results.
• Inspect for bend, damage or kinks of oil cooler line
Yes
pipes. If okay, overhaul control valve body and repair or
replace any defective parts.
(See ATX Workshop Manual.)
• If problem remains, replace or overhaul transaxle and
repair or replace any defective parts.
(See ATX Workshop Manual.)
No Replace torque converter.
Yes Go to symptom troubleshooting No.24 "Engine stalls when
shifted to D range, or in R position".
No Repair or replace any defective parts according to
inspection results.
Yes Go to next step.
No Inspect meter fuse.
ACTION
A6E578001030228
ACTION
A6E578001030229
A6E578001030230
ACTION