Test Alias Name, Device Path, -All - Sun Microsystems Sun Ultra 60 Service Manual

probe-scsi Output Message
CODE EXAMPLE 4–5
ok probe-scsi
Target 0
Unit 0 Disk
Target 6
Unit 0 Removable Read Only device
4.6.4

test alias name, device path, -all

The test command, combined with a device alias or device path, enables a device
self-test program. If a device has no self-test program, the message:
No selftest method for device name is displayed. To enable the self-test
program for a device, type the test command followed by the device alias or device
path name.
Code Example 4–6 identifies the test output message. Table 4–6 lists
test alias name selections, a description of the selection, and preparation.
Note -
test Output Message
CODE EXAMPLE 4–6
ok test floppy
Testing floppy disk system.
Test succeeded.
TABLE 4–6
Type of Test
test screen
test floppy
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
4-10
QUANTUM VK4550J SUN4.2G8600
TOSHIBA XM5701TASUN12XCD0997
The diskette drive is selected as the test alias name example.
A formatted disk should be in the drive.
Selected OBP On-Board Diagnostic Tests
Description
Tests system video graphics
hardware and monitor.
Tests diskette drive response to
commands.
Preparation
Diag-switch? NVRAM
parameter must be true for the test
to execute.
A formatted diskette must be
inserted into the diskette drive.