a. Position the PCI card into the chassis.
b. Lower the PCI card connector so that it touches its associated PCI card slot
c. Guide the PCI card back panel into the chassis backpanel.
d. At the two upper corners of the card, push the card straight down into the
e. Using a Phillips-head screwdriver, replace the screw securing the card
2. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
3. Connect the AC power cord.
4. Detach the wrist strap.
5. Connect all cables to the PCI slots.
6. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
10.4
UPA Graphics Card
To remove and replace a UPA graphics card, proceed as follows.
10.4.1
Removing the UPA Graphics Card
1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-3.
2. Disconnect the video cable from the graphics card video connector.
3. Remove the side access cover.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
10-10
on the motherboard.
slot until the card is fully seated.
bracket tab to the system unit chassis (not illustrated).