Emi Filler Panels; Removing An Emi Filler Panel - Sun Microsystems Sun Ultra 60 Service Manual

c. Replace the diskette drive cable connector to the diskette drive.
d. Connect the SCSI cable to the CD-ROM drive (or tape drive).
e. Replace the drive tray.
3. Connect the AC power cord.
4. Detach the wrist strap.
5. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
6. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
8.5

EMI Filler Panels

To remove and replace the EMI filler panels from the front bezel or the drive tray,
proceed as follows.
8.5.1

Removing an EMI Filler Panel

1. Identify the EMI filler panel to be removed.
2. Remove an EMI filler panel as follows (Figure 8–5):
a. Remove the front bezel.
b. Use your finger to pop the EMI filler panel from the bezel.
3. Remove the drive tray drive.
See Section 9.2.1 "Removing the RMA" on page 9-4.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
8-14
See Section 9.2.6 "Replacing the RMA" on page 9-9.