Dimm - Sun Microsystems Sun Ultra 60 Service Manual

c. Lower the UPA graphics card connector so that it touches its associated UPA
Caution -
side of the board.
d. At the two upper corners of the card, push the card straight down into the
e. Using a Phillips-head screwdriver, replace the screw securing the card
2. Connect the AC power cord.
3. Detach the wrist strap.
4. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
5. Connect the video cable to the graphics card video connector.
6. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
10.5

DIMM

To remove and replace a DIMM, proceed as follows.
card slot on the motherboard.
Avoid damaging the connector by not applying force to one end or one
Note -
The UPA graphics card connector is a double-row connector that
requires two levels of insertion. When installing the graphics card, ensure that
the connector is fully seated into the slot.
slot until the card is fully seated.
bracket tab to the system unit chassis.
Motherboard and Component Replacement
10-13